1-Span offset wire links can now be placed to left or right and above/below relative any row of holesįixed bug for wires where a copied wire did not copy across all the parameters for insulated wire endsįixed bug to correctly display the AXE029 module when selected for the 28/40 pin PICAXE parts 1-Span wires can now go in any one of 16 nominal directions from any hole Options for bare and insulated 1-span wire links originating from a hole with and without small spot-face cut A 2-hole high x 6 hole wide blank mask for use primarily at top side of strip boards as off-board area A 2-hole wide x 10 hole high blank mask for use primarily at left side of strip boards as off-board area Three variants of insulated 1-span cross over wires with various wire colour options Modified the new Strip/Prototyping board parts/edits ("ProtoBrd" group) dialog box to provide added selections for 1-span pre-defined links. Some icons on the floating menu re-positionedįixed bug where some terminal group items did not show the correct image on first selection if user selected wrong # of pins (but would on re-entering properties window)įixed bug where selection area for IC's extended 1 row below the bottom of the imageĪdded 0.0 Ohm resistor option and altered gold band shading (so less like yellow) for values < 1.0 OhmsĪdded vertical stereo programming sockets suitable for soldering to end of strip boards Split the "ProtoBrd" group into two - One for 1-Span wire lines and second for strip cuts and other editsĪdded a new "Floating" group similar to the "Notes" which can hold components/items that will not be locked to the grid for positioning Included notes on how to add a new component (in the Support folder) Included notes on how to add a new breadboard (in the Support folder) Fixed problem where Load/Save function failed when 1-span wire links were included.Īdded 90 degree bends to the 1-Spare wire links range to improve routing flexibility.Įxpanded the localisation translations for Czech and Spanish languages
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |